Skip to content

5858-160GFD - 16"/16.5" x 6" Universal - Under the Lug Simulator Set 8 Lug, 4 Hand Holes

$ 185.99

16"/16.5" x 6" Universal - Under the Lug Simulator Set 8 Lug, 4 Hand Holes

Fits the following dual rear wheel vehicles:

1980 – 1998 GM, Ford & Dodge Trucks

16" & 16.5" x 6", 4 Hand Holes/Air Holes and 8 Lug Nuts

One set includes:
2 Front Liners/Dishes
2 Rear Liners/Dishes
2 Front Hub Covers
2 Rear Hub Covers
4 Retainer Rings
1 Tool

These are 304-Grade Stainless Steel. You just need soap and water to clean them up!

INSTALLATION INSTRUCTIONS:
Application applies to original equipment manufacturer’s standard production wheels only.
1. Place jack under appropriate wheel axle and raise the weight off your tires.
2. Remove every other lug nut from your wheel (and the steel lock ring if a GMC vehicle).
3. Place the appropriate simulator over the studs with the hand holes aligned with the hand holes on the rim. If a GMC vehicle, replace the lock ring on top of the simulator.
4. Install the retainer ring as follows:
*** For Ford and Dodge-install on top of the liner with the lip of the retainer ring facing away from the rim.
*** For GMC-install on top of the liner with the lip of the retainer ring facing the rim to cover the lock ring.
5. Reinstall and tighten down all the lug nuts. Be sure to use the recommended torque value, which is noted in your vehicle manual.
6. Finally, pop the front and rear hub covers on to the retainer ring.
Installation is complete!

Picture shows 1/2 set, 1 Front & 1 Rear plus hardware. Each box contains complete set for 4 wheels.

SOLD ONLY IN FULL SETS