5898-195F - 19.5" x 6.75" Over Lug Design Simulator Set, 8 Lug, 4 Hand Hole
19.5" x 6.75" Over Lug Design Simulator Set for Ford, International, Freightliner, Hino, Lo-Pro 8 Lug, 4 Hand Hole 2003-Current
Fits the following dual rear wheel vehicles:
2003 – Current Ford, International, Freightliner, 2007 Hino, Lo-Pro, Rim #28680
19.5" x 6.75", 4 Hand Holes/Air Holes and 8 Lug Nuts
One set includes:
2 Front Liners/Dishes with Pop-off Hub Covers
2 Rear Liners/Dishes
16 Lug Nuts (22mm thread)
16 Lug Nut Covers
These are 304-Grade Stainless Steel. You just need soap and water to clean them up!
Application applies to original equipment manufacturer’s standard production wheels only.
There is no need to jack up your vehicle or remove any lug nuts when installing this wheel liner set.
1. Install the liner on to the wheel
2. Screw the enclosed lug nuts down on the studs extending up through the lug nut holes in the liners. These nuts will hold the liners securely in place. Be sure to install the nut so that the correct shoulder on the nut is used. For short studs, the long shoulder on the nut should install first on the stud. For long studs, the short shoulder on the nut should install first on to the stud. There are four (4) Lug Nuts for each wheel.
3. Using the tool provided with this set, hand tighten the Lug Nuts. DO NOT use a power wrench for this purpose.
4. Install the four (4) enclosed lug nut covers over the exposed installation lug nuts.
Installation is complete!
Picture shows 1/2 set, 1 front & 1 rear plus hardware. Each box contains complete set for 4 wheels.
OVERSIZED SHIPMENT – Dimensional Weight Applies
SOLD ONLY IN FULL SETS