5815-225 - 22.5" x 7.5" Over Lug Design Simulator Set - Hub Pilot Wheel 10 Lugs, 5 Hand Holes
22.5" x 7.5" Over Lug Design Simulator Set Hub Pilot Wheel 10 Lugs, 5 Hand Holes
Fits the following dual rear wheel vehicles:
22.5" x 7."
5 Hand Holes/Air Holes and 10 Lug Nuts
One set includes:
2 Front Liners/Dishes with Pop-off Hub Covers
2 Rear Liners/Dishes
2 Rear Hub Covers
20 Adapter Cups
20 Jam Nuts (28.5mm)
These are 304-Grade Stainless Steel. You just need soap and water to clean them up!
Application applies to original equipment manufacturer’s standard production wheels only.
There is no need to jack up your vehicle or to remove any lug nuts when installing this wheel liner set.
1. Install the liner on to the wheel by lining up the hand hole to wheel’s hand hole. Align the dummy nut covers on to the lug nut, which will allow every other lug nut exposed.
2. Drop the adapter cup on to the exposed lug nut through the stud.
3. Screw the extra lug nut covers with nuts and adapter cup down on the studs, which will press the adapter cup on to the liner. There are five (5) extra lug nut covers with nuts for each wheel.
4. Tighten the extra nut covers with nuts on to the liner. DO NOT use a power wrench for this purpose.
Installation is complete!
Picture shows 1/2 set, 1 Front & 1 Rear plus hardware. Each order contains complete set for 4 wheels. Two boxes, one for fronts and one for rears.
OVERSIZED SHIPMENT – Dimensional Weight Applies
SOLD ONLY IN FULL SETS